Lenoxx Electronics Clock Radio CR 776 User Manual

®
JUMBO DISPLAY  
AM / FM CLOCK RADIO  
MODEL CR-776  
OPERATING INSTRUCTIONS  
EASY TO READ JUMBO CLOCK DISPLAY  
WAKE UP TO RADIO OR ALARM  
AM/FM RADIO RECEIVER  
ELECTRONIC DIGITAL CLOCK  
PM & AUTO INDICATORS  
SNOOZE FUNCTION (FOR EXTRA 9 MINUTES SLEEP)  
SLEEP TO RADIO (WITH AUTOMATIC SHUTOFF)  
BATTERY BACK-UP (9V BATTERY, NOT INCLUDED)  
PLEASE READ CAREFULLY BEFORE USE  
CR-776_031500 NL v.2  
E
 
SAFETY INSTRUCTIONS  
11. Power Cord Protection - Power supply cords should be routed  
so that they are not likely to be walked on or pinched by items  
placed upon or against them, paying particular attention to cords at  
plugs, convenient receptacles, and the point where they exit from  
the appliance.  
12. Cleaning - The appliance should be cleaned only as recommended  
by the manufacturer.  
13. Nonuse periods - The power cord of the appliance should be  
unplugged from the outlet when left unused for a long period of time.  
14. Object and Liquid Entry - Care should be taken so that objects do  
not fall and liquids are not spilled into the enclosure through  
openings.  
15. Damage Requiring Service - The appliance should be serviced  
by qualified service personnel when:  
A. The power supply cord or the plug has been damaged; or  
B. Objects have fallen, or liquid been spilled into the appliance; or  
C.The appliance has been exposed to rain; or  
D.The appliance does not appear to operate normally or exhibits  
a marked change in performance; or  
E. The appliance has been dropped, or the enclosure damaged.  
16. Servicing - The user should not attempt to service the appliance  
beyond that described in the operating instructions. All other  
servicing should be referred to qualified service personnel.  
17. Power lines - An outdoor antenna should be located away from  
power lines.  
18. Outdoor Antenna Grounding - If an outside antenna is connected  
to the receiver, be sure the antenna system is grounded so as to  
provide some protection against voltage surges and built up static  
charges. Section 810 of the National Electrical Code, ANSI/NFPA  
70 provides information with respect to proper grounding of the  
mast and supporting structure, grounding of the lead-in wire to an  
antenna discharge unit, size of groundingconductors, location of  
antenna-discharge unit, connection to grounding electrodes, and  
requirements for the grounding electrode. See Figure.  
EXAMPLE OF ANTENNA GROUNDING AS PER  
NATIONAL ELECTRICAL CODE  
ANTENNA  
LEAD IN WIRE  
GROUND  
ANTENNA DISCHARGE  
CLAMP  
UNIT (NEC SECTION  
810-20)  
GROUNDING  
CONDUCTORS  
(NEC SECTION 810-21)  
ELECTRIC  
SERVICE  
EQUIPMENT  
GROUND CLAMPS  
POWER SERVICE GROUNDING  
ELECTRODE SYSTEM  
(NEC ART 250, PART H)  
2
CR-776_031500 NL v.2  
E
 
LOCATION OF CONTROLS  
FRONT VIEW  
PM INDICATOR CLOCK DISPLAY  
DIAL SCALE  
TUNING  
CONTROL  
VOLUME  
CONTROL  
AUTO (ALARM) INDICATOR  
TOP VIEW  
FUNCTION SWITCH  
(ALARM/AUTO/OFF/ON)  
TIME SET  
BUTTON  
DIMMER  
SWITCH  
BAND  
SWITCH  
SLEEP  
BUTTON  
HOUR SET  
BUTTON  
MINUTE SET  
BUTTON  
ALARM SET/  
OFF BUTTON  
SNOOZE  
BUTTON  
BACK VIEW  
BATTERY  
COMPARTMENT  
(9V, for back up)  
FM ANTENNA WIRE  
AC POWER CORD  
3
CR-776_031500 NL v.2  
E
 
OPERATING INSTRUCTIONS  
Powering Up  
Plug the AC power cord into a 120V, 60Hz electrical outlet. The clock  
display will light up and flash indicating the power is on.  
NOTE: This cord is polarized. This means the cord will only fit one  
way into the socket or wall outlet. If it does not fit, do not force  
it, just reverse it and try again.  
BATTERY BACK-UP  
If the AC cord is disconnected or if there is a short time power failure,  
this electronic clock and timer are designed to continue operating  
internally (without showing in the display) if a 9 volt battery (not included)  
is installed.  
The radio will work fine without this back up battery.  
NOTE: You may check the condition of the battery every few months  
by disconnecting the AC cord and connecting it again 2 or 3  
minutes later. The preset times will show. If the time flashes, it  
indicates the battery is dead or not connected properly.  
Setting the Clock  
1. Press the TIME set button together with the HOUR set button until the  
display shows the desired hour.  
2. Press the TIME set button together with the MINUTE set button until  
the display shows the desired minutes.  
NOTE: When the PM indicator is off, the time is AM.  
Setting the Alarm Time  
1. Use the ALARM/OFF button to check the alarm time.  
2. Press the ALARM/OFF button together with the HOUR set button  
until the display shows the desired alarm hour time.  
3. Press the ALARM/OFF button together with the MINUTE set button  
until the display shows the correct alarm minutes.  
4. Make sure the PM lamp is off if you want the clock to wake you in the  
morning.  
5. Release the ALARM/OFF button, the clock display will show the  
normal time of day.  
NOTE: Again check the PM indicator. If you want the radio to wake  
you in the morning, the lamp next to PM should be off on alarm  
time (when pressing ALARM/OFF button). To change PM to  
AM time, advance time 12 hours. To have clock wake you up,  
slide the FUNCTION switch to AUTO or ALARM position(s).  
Playing the Radio  
1. Slide the FUNCTION switch to ON position.  
2. Slide the BAND switch to either AM or FM.  
3. Turn the TUNING control to your desired station.  
4. Adjust the VOLUME control to your favorite listening level.  
5. Slide the FUNCTION switch to OFF position to shut off the radio.  
GETTING BETTER RADIO RECEPTION:  
For best AM reception, rotate the radio a small amount or position it  
near the window.  
For best FM reception, unwrap and fully extend the FM antenna wire.  
WARNING: Do not connect the FM antenna to an outdoor antenna.  
4
CR-776_031500 NL v.2  
E
 
OPERATING INSTRUCTIONS  
Waking up to Radio  
1. Set the alarm time as previously instructed.  
2. Select your desired AM or FM broadcast by following the procedure  
of Playing the Radio.  
3. Make sure the VOLUME control is set loud enough to wake you up.  
4. Slide the FUNCTION switch to AUTO position and the AUTO lamp  
will light up.  
NOTE: Your set is now ready to turn on automatically at your  
selected alarm time.  
5. When alarm sounds, to get 9 minutes of extra sleep, press the  
SNOOZE button.  
6. To shut off the alarm, press ALARM/OFF button.  
Wake to Buzzer  
1. Set the alarm time as previously instructed.  
2. Slide the FUNCTION switch to ALARM position. The AUTO  
indicator will light.  
3. The buzzer alarm is now set to turn on automatically at the  
selected alarm time.  
4. When buzzer sounds, to get 9 minutes of extra sleep, press the  
SNOOZE button.  
5. To shut off the alarm, press ALARM/OFF button.  
Snooze Control  
When this set has waken you up and you wish to sleep a few minutes  
more, simply press the SNOOZE button. The radio or alarm will go off  
for 9 minutes and then come on again. This is repeated in a row.  
Alarm Off  
1. Press ALARM/OFF button. This will shut the alarm for that day only.  
Next day the set will wake you again at the same time.  
2. Slide the FUNCTION switch to OFF position and the alarm function  
is off until you re-adjust the FUNCTION switch to AUTO or ALARM.  
Sleep Control  
The SLEEP control will allow the radio to play 58 minutes (or 1 hour and  
59 minutes) before the radio turns itself off.  
1. Press the SLEEP button, the display will show 58 minutes and the  
radio will start to play.  
2. Holding the SLEEP button down, the display will count down.  
Release the SLEEP button when the display shows your desired  
amount of time you want the radio to play before shutting itself off.  
3. Pressing the SLEEP button, the HOUR set button, and the MINUTE  
set button all simultaneously down, the required sleep time will be  
changed to 1 hour and 59 minutes. You may reduce the sleep time  
by following the above Step 2.  
4. To turn the radio off before the playing time has expired,  
simply press the SNOOZE button.  
NOTE: The sleep function will not affect the wake-up operation of the  
clock if the FUNCTION switch is in AUTO or ALARM position.  
In the morning, the radio or buzzer will wake you up if FUNCTION  
switch is in the AUTO or ALARM position.  
5
CR-776_031500 NL v.2  
E
 
TROUBLE SHOOTING  
(Helpful Hints)  
SHOULD YOUR SET EXHIBIT A PROBLEM, CHECK THE  
FOLLOWING BEFORE SEEKING SERVICE.  
SYMPTOM  
CAUSE  
SOLUTION  
AM or PM not set  
correctly. Is alarm  
time set in AM range  
(PM Lamp off)?  
Advance the clock 12  
hours.  
Alarm does not  
come on in the  
morning.  
FUNCTION switch  
is in OFF position. Is  
the AUTO Lamp off?  
Set the FUNCTION  
switch to AUTO or  
ALARM position.  
FM antenna wire is  
not extended.  
Extend FM antenna  
wire.  
Station not tuned in  
properly.  
Tune to desired station  
carefully.  
FM is distorted  
and weak.  
Weak broadcast  
station.  
Turn to a stronger  
Station.  
Rotate the set to  
receive better signal.  
Signal is blocked.  
Noise or weak  
sound on AM  
broadcasts.  
Turn the radio for better  
AM reception or bring  
set near a window.  
External  
interference.  
FUNCTION switch is Slide the FUNCTION  
switch to ON position.  
in the OFF position.  
No sound.  
VOLUME control set Rotate VOLUME control  
to minimum position. for desired sound.  
Set the clock and alarm  
The clock is not set.  
time.  
The clock is  
flashing.  
A power failure has  
occurred.  
Reset the clock alarm  
time and time of the day.  
Connect set’s AC cord  
and make sure outlet  
has power.  
The set’s AC cord is  
not connected.  
Clock is dead.  
LENOXX reserves the right to make design and specification  
changes for product improvement.  
PROTECT YOUR FINE FURNITURE!  
WE RECOMMEND ACLOTH OR OTHER PROTECTIVE MATERIAL  
BE PLACED UNDER THE SET WHEN PLACING IT ON SURFACE  
WITH A NATURAL OR LACQUER FINISH.  
6
CR-776_031500 NL v.2  
E
 
SPECIFICATIONS  
Power source:  
AC 120V, 60Hz, 8W  
DC 9V battery for backup time memory  
(optional, alkaline batteries are recommended)  
9" (Length)  
Dimensions:  
4 1/4" (High)  
2 3/4" (Depth)  
Frequency range:  
FM 88 - 108MHz  
AM 530 - 1700kHz  
LIMITED WARRANTY  
We warrant this product to be free from defects in material and  
workmanship under normal use for a period of 90 days after  
purchase and we will repair it free of charge or replace it at no charge,  
should it become defective under this warranty, providing you submit  
proof of purchase (sales slip) with the set.  
During the initial 90 day period after original purchase, we will  
service or exchange, at no charge, the set that is returned to  
LENOXX ELECTRONICS CORP.(LENOXX will pay the shipping  
back to you). After the initial 90 day period expires, and for a period  
of 12 months from original purchase, we will repair the unit covering  
any part(s) that need to be replaced at no charge, but will charge for  
the cost of labor, return postage paid by LENOXX.  
This warranty does not apply to any products which have been  
subject to misuse, neglect or accident. This warranty does not cover  
broken headphones or cabinet. UNDER NO CIRCUMSTANCES  
WILL LENOXX ELECTRONICS CORP. BE LIABLE FOR ANY  
INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do  
not allow the exclusion or limitation of incidental or consequential  
damages, so the above limitations or exclusions may not apply to  
you.  
This warranty gives you specific legal rights, and you may also  
have other rights which vary from state to state. The following  
charges apply to repairs beyond the warranty period: $8.00. Be  
sure to pack carefully and return postage paid insured together with  
your money order (personal checks will not be accepted) and sales  
receipt to :  
LENOXX ELECTRONICS CORP.  
2 GERMAK DRIVE, CARTERET N.J. 07008  
For customer service  
Dial 1-800-315-5885  
(MONDAY - THURSDAY 09:00 AM - 5:00 PM, FRIDAY 09:00 AM - 1:00 PM EST)  
or Visit Our Website: http://www.lenoxx.com  
© 2000 LENOXX ELECTRONICS CORP.  
2 GERMAK DRIVE  
CARTERET, N.J. 07008  
MADE & PRINTED IN CHINA  
7
CR-776_031500 NL v.2  
E
 

Learning Resources Games LER 0753 User Manual
Lexmark All in One Printer 746de User Manual
LG Electronics Flat Panel Television 19LG30 User Manual
Life Fitness Exercise Bike 95C IFIXX XX User Manual
Lightolier Indoor Furnishings VTS2GPK332 User Manual
Lochinvar Swimming Pool Heater CP 501 751 User Manual
Marcum Technologies Radar Detector LX i User Manual
Marshall Amplification Stereo Amplifier VBA400 User Manual
Maytag Clothes Dryer MDG17MN User Manual
Melissa Landscape Lighting 677 001 User Manual